800 and 1000 liter mounted reverse atomizer sprayer

Description

Garden turbine sprayer

Reverse Atomizer Sprayer is very suitable for spraying all kinds of gardens

Complete covering of leaf and stem surface of trees with suitable volume of produced air and spraying of nozzle powder

• Polyethylene poison tank with a capacity of 800 and 1000 liters
• Equipped with system wash tank and hand wash
• Valved door
• Resistant to sunlight
• Hydraulic stirrer crack
• Poison tank water level indicator
• Three-way valve leaves the poison tank
• The fan has a diameter of 800 and 900 mm and is equipped with a reverse system
• Ability to distribute the wind evenly throughout the fan surface and the consequent wind outflow to an extent from each network
• Inlet air suction from behind the fan to prevent dust, soil, branches and leaves of trees from entering the fan
• It has 2 fixed impellers and one movable impeller
• Adjustable valves and air direction, for uniformity and adjusting the angle and direction of spraying the poison
• Spray terminal for uniform distribution of toxin to each nozzle and, consequently, the exit of toxin from the nozzle to an equal extent
• Spraying width 12 meters on each side and 10 meters upwards
• The fan parts consist entirely of bent sheets and laser cut with thicknesses of 2, 3 and 5 mm.
• It has a large two-speed gearbox that increases the Italian fan speed
• Ability to install 800 fan with 14 Italian nozzles, double head brass and anti-drip with fully powdered and uniform spray of poison solution and 900 fan with 16 Italian nozzles, double head brass and anti-drip with fully powder and uniform spray of poison solution
• All hoses used in chassis and fan are high pressure hoses with a layer of steel wire

Reverse atomizer sprayer chassis mounted

• High-strength and standard mounting chassis equipped with automatic pin lock, for easy and safe connection of the sprayer to the tractor and the automatic regulator valve handle
• Chassis composed entirely of bent sheets and laser cut with thicknesses of 5, 8 and 12 mm
  Steel wheel for easy movement of the device
• Assemble the hose reel and a 5-layer hose loop and lance
• Fill system crack
• Valve filter 160 cracks
• 80 cm steering wheel crack
• Two cracked brass shingles filters are installed separately to enter the nozzles on the left and right side of the fan.
• The body of the fan and chassis is covered with six layers of epoxy primer and six layers of metallic car paint with a pencil tip.
• Comet 121 Italy diaphragm pump with 50 bar pressure and flow rate of 114 liters per minute
• Ability to install Italian Comet 145 diaphragm pump with 50 times pressure and flow rate of 142 liters per minute.