All hydraulic wing sprayer
All-hydraulic wing sprayer The best type of sprayer in terms of uniformity in spraying the poison solution, complete coverage of the product surface and not damaging them
- 2000 liter polyethylene poison tank, equipped with system wash tank and hand wash
- Valved door
- Resistant to sunlight
- Hydraulic stirrer crack
- Poison tank water level indicator
- Three-way valve to leave the tank
- Sprayer wing length 18 meters, spray width 25 meters, has 36 long base brass nozzles with anti-drip valve strainer and 2 nozzles (XT024) increasing the spray spray length
- The hoses used in the wings are threaded hoses with a diameter of 10 mm and 5 layers
- The type of poison pipe is polyethylene with brass fittings for installing poison hoses
- Has a control valve with 5 outlets for separate hose, to each part of the wing and connecting the lance to the sprayer
- Fill the crack system
- Valve filter 220 cracks and 4 brass cracker filters equipped with drain valve at the inlet of poison to the wings
- Collect the hose roller
- Ward guard left parasite
- Adjust the wing height from the product surface hydraulically up to 120 cm
- Wing opening and closing hydraulically
- Equipped with wing balance system and suspension system
- Impact spring hinge and lightweight and durable polyethylene wheels at the end of the two wings
- To prevent wing damage when hitting the ground or obstacles
All-hydraulic wing sprayer chassis
- The traction chassis has a standard two-point connection for easy connection to the tractor and proper controllability following the tractor and a single point connection, the harness is sliding adjustable.
- The-chassis parts consist of fabric studs of 140 x 8 mm and other laser-cut parts with thicknesses of 5, 8, 12 and 20 mm.
- The hoses used in the chassis are high pressure hoses of a single layer of steel wire.
- Chassis with spring wheel axle with the ability to adjust the height up to 18 cm vertically in 3 modes and adjust the horizontal distance between the wheels in 5 modes
- It has a pair of flat tires and a pair of truck fenders to prevent mud from splashing into the device.
- The wings and chassis are covered with six coats of epoxy primer and six coats of metallic car paint with a pencil tip.
- Ability to install diaphragm pumps 96 pressure crack 50 bar and flow 88 liters per minute
- Bertolini poly 2150 pump with 15 bar pressure and flow of 150 liters per minute
- Bertolini PPS100 Italian pump with 40 bar pressure and 95 liters per minute flow
- Comet 121 Italian pump with 50 bar pressure and 114 liters per minute flow
- Comet 145 Italian pump with 50 bar pressure 142 liters per minute