trailed atomizer sprayer 1000 and 2000 liter

Description

Atomizer sprayer

Garden turbine sprayer (traction atomizer) is very suitable for spraying all kinds of gardens

Complete covering of leaf and stem surface of trees with suitable volume of produced air and spraying of nozzle powder

• Polyethylene poison tank with a capacity of 1000 and 2000 liters, equipped with system wash tank and hand wash
• Valved door
• Resistant to sunlight
• Hydraulic stirrer crack
• Three-way valve leaves the poison tank
• Poison tank water level indicator
• Fan diameter 800 and 900 mm with the ability to distribute the wind evenly throughout the fan surface. Following that, the wind exits the same amount of individual networks, has 2 fixed
• impellers and one mobile impeller.
• It has adjustable valves and air direction, for uniformity and angle adjustment and for spraying poison.
• Has a spray terminal to uniformly distribute the toxin to each nozzle and consequently the toxin out of the nozzle to an equal extent.
• Spraying width 10 meters on each side and 8 meters upwards
• The fan parts consist entirely of bent sheets and laser cut with thicknesses of 2, 3 and 5 mm.
• It has a large two-speed gearbox that increases the Italian fan speed
• It has 14 Italian nozzles in 800 mm fan and 16 Italian nozzles in 900 mm fan
• Double-headed and anti-drip brass nozzles with fully powdered and uniform spray of poison solution
• All hoses used in chassis and fan are high pressure hoses with a layer of steel wire.

Tensile atomizer sprayer chassis

• Traction chassis with standard two-point connection for easy connection to the tractor and proper controllability following the tractor and single-point connection.
• Sliding and adjustable bearing. Chassis parts consisting of fabric studs 8 × 140 mm. Other parts are laser cut with thicknesses of 5, 8, 12 and 20 mm.
• The chassis has a spring wheel axle to adjust the vertical height up to 18 cm in 3 modes and adjust the horizontal distance between the wheels in 5 modes.
• Has a pair of flat tires
• A pair of truck fenders to prevent mud from splashing into the device.
• Has a crack filling system
• Valve filter 220 cracks
• Ward guard left parasite
• Two cracked brass shingles filters are installed separately to enter the poison to the left and right nozzles of the fan.
• The body of the fan and chassis is covered with six layers of epoxy liner and six layers of metallic car paint with a pencil tip.
• With Italian Comet 121 diaphragm pump with 50 bar pressure and flow rate of 114 liters per minute
• Comet 145 Italian pump with 50 bar pressure and flow rate of 142 liters per minute