Description
Reverse Atomizer Sprayer
Tensile reverse atomizer sprayer and mounting atomizer sprayer is very suitable for spraying all kinds of gardens
Complete covering of leaf and stem surface of trees with suitable volume of produced air and spraying of nozzle powder
The reverse model of these sprayers is used for gardens with dense trees.
- Polyethylene poison tank with a capacity of 1000 and 2000 liters
- Equipped with system wash tank and hand wash
- Valved door
- Resistant to sunlight
- Hydraulic stirrer crack
- Has a drain tank drain valve and a water tank indicator for the poison tank
- The three-way valve of the poison poison tank is equipped with a reverse system
- Ability to distribute the wind evenly throughout the fan surface and the consequent wind outflow to an extent from each network
- Inlet air suction from behind the fan to prevent dust, soil, branches and leaves of trees from entering the fan
- It has 2 fixed impellers and one movable impeller
- Adjustable valves and air direction, for uniformity and adjusting the angle and direction of spraying the poison
- Has a spray terminal to uniformly distribute the toxin to each nozzle and, consequently, the toxin out of the nozzle to an equal extent
- Spray width 15 meters on each side
- Fan parts are completely composed of bent sheets and laser cut with thicknesses of 2, 3 and 5 mm.
- It has a large two-speed gearbox that increases the Italian fan speed
- Ability to install 900 fan with 16 and 800 fan with 14 Italian nozzles, anti-drip brass with full powder spraying and uniform poison solution
- All hoses used in the chassis and fan are high pressure hoses with a layer of steel wire.
Tensile reverse atomizer sprayer chassis
- Traction chassis with standard two-point connection for easy connection to the tractor and proper controllability following the tractor and single-point connection
Sliding and adjustable bearing - Chassis parts consist of 140 x 8 mm fabric studs. Other parts are laser cut with thicknesses of 5, 8, 12 and 20 mm.
- The chassis has a spring-loaded wheel to adjust the vertical height up to 18 cm in 3 modes and adjust the horizontal distance between the wheels in 5 modes.
- A pair of flat tires
- It has a pair of truck fenders to prevent mud from splashing into the device
- Fill the crack system
- Valve filter 220 cracks
- Ward guard left parasite
- Two cracked brass shingles filters are installed separately to enter the poison to the left and right nozzles of the fan.
- The body of the fan and chassis is covered with six layers of epoxy primer and six layers of car metallic paint.
- Ability to install Italian Comet 145 diaphragm pump with a pressure of 50 bar and a flow rate of 142 liters per minute.
- Comet 121 Italy diaphragm pump with 50 bar pressure and flow rate of 114 liters per minute
Reviews
There are no reviews yet.